The Photoluminescence quantum yield or PLQY of a molecule or material is defined as the number of photons emitted as a fraction of the number of photons absorbed. This characteristic property of a fluorophore or fluorescent molecule is important for understanding molecular behavior and interactions for many key materials.
Similarly, the electroluminescence quantum yield, or ELQY, is the number of photons emitted divided by the electron current of a device. This is important for lighting, display devices, and photovoltaic materials.
The materials for which PLQY and ELQY are used are:
There are three ways to measure PLQY: the comparison method, fluorescence lifetime, and the direct method (integrating sphere).
In the Comparative method, one uses a reference standard, a sample with known emission and absorbance properties close to that of the sample of interest, and has a known PLQY value. The absorbance and fluorescence of the reference standard are measured and then the same is measured for the sample under study.
The following equation is used where QF is the quantum yield of the unknown fluorescent sample, QR is the quantum yield of the reference standard, IF and IR are the integrated fluorescence intensities for the unknown and the reference, respectively, and AF and AR are the absorbance values of the unknown and reference, respectively. A limited amount of reference standards make this method somewhat limited as well.
There is a method that uses fluorescence lifetimes and different concentrations of a quencher to calculate the quantum yield of a molecule.
The equation on the right is used where tf is the quantum yield, and kf, knr, and kt are the rate constants of fluorescence, non-radiative dissipation and energy transfer, respectively, τf is the fluorescence lifetime of the sample. PLQY is determined by the rate constants of these non-radiative processes that compete with fluorescence such as FRET and Stern-Volmer quenching.
By adding a dilution series of quencher to a fluorescent solution, the PLQY can be calculated by finding the Stern- Volmer quenching constants (K) and the bimolecular quenching constant (kq). While this is certainly a robust method, it requires a good amount of sample preparation and is not convenient for solid samples.
The integrating sphere method is a direct method of measuring PLQY. A sphere is coated with an all reflective surface, such as barium sulfate-based materials or Spectralon® to capture all the light going in and out of the sphere.
A measurement is done of the fluorescence emission (Ec) and the scatter (Lc) of the sample and also the emission and scatter of a blank (La and Ea). From these two spectral measurements (sample and blank), the PLQY can be calculated from the equation in Fig. 24.
Where Eb is the integrated luminescence from the sample caused by indirect luminescence from the sphere and A is the absorbance of the sample at the excitation wavelength. A simple calculator that incorporates the two traces along with appropriate spectral correction factors is used to give the PLQY and associated error analysis.
Do you have any questions or requests? Use this form to contact our specialists.