XGT-5000WR solves various analytical problems and difficulties

The introduction of the XGT-5000WR into a laboratory provides fundamental solutions to a wide-range of analytical work problems, problems that could not be resolved with conventional systems.

In this section, we will examine some specific examples of these problems, looking at the factors that caused the problems and the ways in which the XGT-5000WR solved the problems.

Face

It takes a lot of time and effort to cut cross sections of foreign substances.

The process of cutting out a sample could take half a day.
And, the foreign substance sample could be damaged or completely destroyed during the cutting process.

XGT solves this problem !

Face

You need to perform element analysis for a sample containing water.

Too much time and work is involved in drying the sample.
The sample would be destroyed if it were dried.

XGT solves this problem !

Face

You need to locate a malfunction on a circuit board without damaging the circuit board.

You have no idea where the malfunction is.
You need to analyze the circuit board as a package.
If the circuit board is disassembled, it will be impossible to locate the malfunction.

XGT solves this problem !

Face

You need to analyze a large sample.

With conventional systems, there is no way to check for uneven element distribution over a large area.
It would take a lot of time and effort to divide a large sample into smaller pieces and to perform repeated analyses.

XGT solves this problem !