Measurement of Potassium in Soil  

LAQUAtwin is a series of compact water quality testers. Using Ion Specific Electrode (ISE) technology, they are available for Conductivity, Calcium ion, Nitrate ion, Potassium ion, Sodium ion and pH measurement. Using just a single drop of sample, the LAQUAtwin proprietary flat sensors can quickly and accurately measure the values of the chemical parameters for quality check of food in production lines.


Typically, Atomic Absorption (AA) or Inductivity Coupled Plasma-Optical Emission Spectrometry (ICP-OES) is used to measure potassium ion, by first extracting the potassium ion from sample soils by 1 mol/L ammonium acetate (CH3COONH4). These are the methods performed in laboratories.

A simpler method for a rapid measurement of potassium ion in soil uses the LAQUAtwin potassium ion meter B-731. The extraction method is the same as the lab method. The following procedure explains how you can measure K+ with good correlation to analytical lab tests.


  1. Put 1g each of air-dried soils (four samples) in 100mL glass beakers, two beakers per soil sample.
  2. Prepare two kinds of extraction per soil sample, one by adding 20 ml of 1mol/L CH3COONH4 to one beaker, and 20ml of 0.01mol/L CH3COONH4 to another beaker.
  3. Shake the beakers around 1 hour to extract K+ from the soil using a bench top shaker.
  4. Calibrate LAQUAtwin B-731 with 150mg/L and 2000mg/L K+ standard solutions included in the product.
  5. Measure potassium ion concentration of the filtrated solution with calibrated B-731 and with ICP-OES (e.g. HORIBA Jobin Yvon. Model ULTIMA2).
  6. Perform this measurement with 4 different samples.

Results and Benefits

The Laqua Twin B-731 allows for a simple on site determination of potassium which provides accuracy close to laboratory techniques.

1Table 1 shows the results from ICP-OES and LAQUAtwin K+ extracted with 1 mol/L and 0.01 mol/L CH3COONH4.

Click on image to enlarge

Based on table 1, higher value against ICP-OES is detected by LAQUAtwin K+ with 1 mol/L CH3COONH4 extraction, due to strong interference by NH+ of CH3COONH4. However, with 0.01 mol/L CH3COONH4 extraction, although the extraction efficiency is reduced by approximately 80%* (Figure 1), very good correlation (R=0.981, R2=0.962) is obtained between ICP-OES and LAQUAtwin (Figure 2).

Figure 1 shows the potassium extraction efficiency measured with ICP-OES. Setting 1 mol/L CH3COONH4 extraction as 100%, efficiency trend is plotted depending on different CH3COONH4 concentration.

Figure 2 shows the correlation between ICP-OES and LAQUAtwin K+ measurements with 0.01 mol/L CH3COONH4 extraction.

Click on image to enlarge

1 Internal study by HORIBA labs, 2013

HORIBA Offices

Asia & Oceania


HORIBA Instruments (Singapore) Pte Ltd.
83 Science Park Drive, #02-02A,
The Curie 118258 Singapore
work +65 6 908 9660
work fax +65 6 745 8155

Europe, Middle East & Africa


HORIBA UK Limited Northampton Office
Kyoto Close,Summerhouse Road,
Moulton Park
Northampton NN3 6FL UK
work +(44) 1604 542 600
work fax +(44) 1604 542 699