PTFM-ONE-DT

Dual Pitot Tube Exhaust Flow Meter

The Dual Pitot Tube Flow Meter, PTFM-ONE DT is a standalone interface for measuring exhaust gas flow rate of combustion engines. The system uses the tried-and-tested pitot tube principle with high-frequency transducers, with a sampling rate of 1kHz to accurately measure highly pulsating exhaust flows. This rapid capture rate ensures that any pulsations or exotic behaviour caused by the engine is measured, and the unique design of the PTFM-ONE DT means reverse flows can be calculated, with the same guarantee of sensitivity.

The interface can run standalone with a laptop, or seamlessly integrated to run alongside a Test Automation System.

Segment: Automotive
Manufacturing Company: HORIBA UK Limited
900°C Exhaust Gas LimitAllows the freedom to test engines under extreme conditions without worrying if the
flow meter can handle those temperatures
-1.25kPa to +7.5kPa
Sensor Range
Shows both positive flow & negative flow in the tailpipe. Also, HORIBA capped the
positive pressure at +7.5kPa to ensure we cause as little backpressure on your
engine as possible
Dual Tube SystemThis is the patented setup of 2 pitot tubes and a valve to switch automatically to
keep the system measuring with it best possible accuracy range. It uses the
smaller tube for flows below 4.5 m3/min and both tubes if flows peak above the
smaller tubes flow limit up to 14.5m3/min.
1Khz High Speed TransducersHaving fast sampling of the pressure changes in the tailpipe allow for a rapid visual
representation of the spikes and negative pulses that happen with a combustion
engine. Lower speed sampling would miss these spikes and negatives giving you
an inaccurate representation of what is happening inside the tailpipe.
Temperature CompensationThe PTFM-ONE automatically compensates to 20°C when testing so there is no
need to warm up.
Multiple Communication
Options
The PTFM-ONE has 2 connection options. LAN for AK connections to Automation
systems or the PTFM Host programme & Analogue out (0-10V with 4 configurable
channels available)
2 Options of
Absolute Pressure Sensors
The PTFM-ONE can be purchased in 2 absolute pressure ranges supporting testing
from sea level to a) 2100m or b) 4500m.
System Configuration
(Standard unit)
  • Dual Pitot Tube Setup (1 for low end & 1 for high end)
  • System Controller
Tube Diameter & Measuring Range

The System comes with a B & C Tube in parallel with each other and a valve in between.

  • B-type: f42.7 / f39.7 mm (0.15 m3/min to 4.5 m3/min)
  • C-type: f60.5 / f56.5 mm (0.3 m3/min to 10 m3/min)

Both B and C Tubes work in parallel with each other, providing a Max Flow of 14.5 m3/min.

Linearity

Either of the following:

  • Within ±2.0 % of full scale
  • Intercept: |a0| ≤ 1.0 % of full scale
    Slope: 0.98 ≤ a1 ≤ 1.02
    Standard estimated error: SEE ≤ 2.0% of full scale
    Coefficient of determination: r2 ≥ 0.990
Flow Rate AccuracyWithin ±1 % of full scale or within ±1.5 % of readings (whichever larger) (at flow rate of 20 % of full scale)
Exhaust Pressure Sensor Range-1.25 – 7.5 kPa
Atmospheric Pressure Sensor Range
  • Standard configuration: 80 to 110 kPa
  • Optional configuration: 60 to 110 kPa
Environment for use
  • Temperature: -20ºC to +40ºC
  • Humidity: Under 80% as relative humidity
  • Altitude: 0m to 2100m above sea level *option for up-to 4500m
Approved StandardsCE, FCC, RoHS compliant
Dimensions923 x 480 x 1204 H x W x D (mm)
Mass115KG Approx.

 

Request for Information

Do you have any questions or requests? Use this form to contact our specialists.

* These fields are mandatory.

Related products

CVS-ONE
CVS-ONE

Constant Volume Sampler

EXFM-ONE
EXFM-ONE

Ultrasonic Exhaust Flow Meter

FTX-ONE-CL
FTX-ONE-CL

FTIR Exhaust Gas Analyzer Dilute Measurement Type

FTX-ONE-CS/RS
FTX-ONE-CS/RS

FTIR Exhaust Gas Analyzer Direct Measurement Type

MDLT-ONE
MDLT-ONE

Micro Dilution Tunnel

MEXA-1170HCLD
MEXA-1170HCLD

Heated Type NOx Analyzer

MEXA-1170HFID
MEXA-1170HFID

Heated Type THC Analyzer

MEXA-1170SX
MEXA-1170SX

Motor Exhaust Gas Sulfur Analyzer

MEXA-1300R
MEXA-1300R

Motor Exhaust Gas Analyzer

MEXA-2000SPCS series
MEXA-2000SPCS series

Solid Particle Counting System

MEXA-584L
MEXA-584L

Automotive Emission Analyzer

MEXA-730λ
MEXA-730λ

Air-to-fuel Ratio Analyzer

MEXA-ONE
MEXA-ONE

Motor Exhaust Gas Analyzer

MEXA-ONE-FT
MEXA-ONE-FT

FTIR Motor Exhaust Gas Analyzer

MEXA-ONE-QL-NX
MEXA-ONE-QL-NX

Laser Spectroscopic Motor Exhaust Gas Analyzer

OBS-ONE GS Unit
OBS-ONE GS Unit

On-board Emissions Measurement System

OBS-ONE PM unit
OBS-ONE PM unit

On-board Emissions Measurement System

OBS-ONE PN Unit
OBS-ONE PN Unit

On-board Emissions Measurement System

OBS-ONE SPN10 Unit
OBS-ONE SPN10 Unit

On-board SPN10 measurement for real-world

OBS-ONE-XL (IRLAM)
OBS-ONE-XL (IRLAM)

On-board NH3/N2O Measurement System for real-world driving

PTFM-1000V2
PTFM-1000V2

Pitot Tube Exhaust Flow Meter

Torque Matching
Torque Matching

Road-to-Rig Chassis Dyno Replication

CRITERION D500
CRITERION D500

Pressure Insensitive Mass Flow Module

CS-600F
CS-600F

Fiber Optic Type Chemical Concentration Monitor

CS-620F
CS-620F

Optical Fiber Type Hot Phosphoric Acid Concentration Monitor

CS-900
CS-900

Non-Contact Chemical Concentration Monitor

CVS-ONE
CVS-ONE

Constant Volume Sampler

D700MG
D700MG

High Speed & Precision Pressure Insensitive Mass Flow Module

D700T
D700T

Best Performance Pressure Insensitive Mass Flow Module

D700uF
D700uF

Micro Flow Pressure Insensitive Mass Flow Module

D700WR
D700WR

Wide Range Pressure Insensitive Mass Flow Module

DZ-100
DZ-100

Ultra-thin Mass Flow Module

EXFM-ONE
EXFM-ONE

Ultrasonic Exhaust Flow Meter

FQ Series
FQ Series

Fuel Flow Measurement Systems

FS-3000
FS-3000

Thermal Flow Splitter

H-1 Series
H-1 Series

Field-installation type water quality measuring instruments

HC-200F
HC-200F

Field-installation Type Fluoride Ion Concentration Meter

HC-200NH
HC-200NH

Field-installation type ammonia nitrogen meter

HC-300F
HC-300F

Field-installation Type Fluoride Ion Concentration Meter

HD-200
HD-200

Field-installation type dissolved oxygen meter (DO meter)

HD-200FL
HD-200FL

Field-installation type optical dissolved oxygen meter (DO meter)

HD-300
HD-300

Field-installation type dissolved oxygen meter (DO meter)

HD-480
HD-480

Panel-mount type dissolved oxygen meter (DO meter)

HD-960L
HD-960L

HF (Hydrofluoric Acid)  DO (Dissolved Oxygen) Monitor / Pure Water DO (Dissolved Oxygen) Monitor

HD-960LR
HD-960LR

Dissolved Oxygen Concentration Monitor Series for Semiconductor Manufacturing

HE-200C
HE-200C

Field-installation type electric conductivity meter (conductivity meter)

HE-200H
HE-200H

Field-installation type electric conductivity meter

HE-200R
HE-200R

Field-installation type electric resistivity meter (resistivity meter)

HE-300C
HE-300C

Field-installation type electrical conductivity meter (conductivity meter)

HE-300R
HE-300R

Field-installation type electric resistivity meter (resistivity meter)

HE-480C
HE-480C

Panel-mount type conductivity meter (conductivity meter)

HE-480C-GC
HE-480C-GC

Carbon Sensor Conductivity Meter (Low concentration type)

HE-480H
HE-480H

Panel-mount type conductivity meter (conductivity meter)

HE-480R
HE-480R

Panel-mount type resistivity meter (resistivity meter)

HE-480R(W)
HE-480R(W)

Resistivity Meter for Semiconductor Cleaning Processes

HE-960CA
HE-960CA

Citric Acid Monitor

Corporate