Chili sauces may contain high amount of salts that increase chances of kidney and heart diseases. To measure the salt content in chili sauce, simply dilute a weighed sample with distilled or deionized water and then place some drops onto the sensor of LAQUAtwin Salt-11 pocket meter. The meter measures the salt content accurately and displays the result in either percentage (%) or parts per thousand (ppt) in just a few seconds.
Chili sauce is a popular condiment that adds spice and flavour to food. It may be hot, sweet, or a combination thereof, and may have a thicker texture and viscosity compared to that of hot sauces. The ingredients of chili sauces vary, but typically include cooked chili peppers, vinegar, sugar, salt and sometimes red tomato. Some chili sauces available commercially are loaded with salt and other preservatives that can be damaging to your health.
Salt, chemically known as sodium chloride (NaCl), is a commonly used seasoning ingredient that serves as flavour enhancer and preservative in packaged or processed foods. It aids in balancing sweetness and suppressing bitterness. It also keeps the growth of pathogenic organisms at bay. Most bacteria, fungi, and other potentially pathogenic organisms cannot survive in a highly salty environment. Such environment is hypertonic, which will dehydrate any living cell causing it to die or temporarily inactivated.
The LAQUAtwin Salt-11 pocket meter offers fast, simple, and easy way of measuring salt content in packaged or processed foods such as chili sauces. This waterproof pocket meter measures the conductivity value of a sample and converts it to salinity value with selected seawater or sodium chloride (NaCl) calibration curve in the meter. The reading on the backlit LCD can be expressed as percentage (%) or parts per thousand (ppt). The replaceable sensor is designed with small sample well, which is embedded with two titanium metal electrodes coated with platinum black. This unique sensor can hold and measure micro-volume sample as little as 0.12ml.
Meter Set-up and Calibration
Select the desired measurement unit and calibration curve combination in the meter settings - either % NaCl or ppt NaCl. Calibrate the meter according to manufacturer’s instructions using 0.5% (5ppt) and 5% (50ppt) NaCl standards that come with the kit.
Sample Preparation and Measurement
Chili sauce should be diluted with distilled or deionized water to liberate the salt. The reading of the diluted sample should fall within the calibrated measurement range of the meter. To obtain accurate results, a uniform temperature should be maintained for the standards and samples.
After measurement, clean the sensor with detergent and warm water. If there are still sample residues or stains after cleaning, place some drops of household bleach (≤5% sodium hypochlorite) onto the sensor and leave it for 5 to 30 minutes. Rinse the sensor with clean water and blot dry with soft tissue. For more information on maintenance, refer to Technical Tip 3: LAQUAtwin Conductivity Sensor Maintenance Procedures.
Chili sauces may contain varying amounts of salt. Salt is soluble in water. It contains 40% sodium (Na), which is a mineral required by the body in small amount for maintaining blood pressure and fluid balance as well as transmitting nerve impulses. Besides salt, sodium is also found in monosodium glutamate (MSG), baking soda, and baking powder. Too much sodium can increase blood pressure and damage kidneys.
For packaged or processed foods, sodium is listed as milligrams (mg) per serving as well as per 100g on the nutrition information panel of the label, rather than salt. Table 1 shows the measurement results of chili sauce with LAQUAtwin Salt-11 pocket meter.
To calculate the amount of sodium from salt (NaCl) reading obtained with LAQUAtwin Salt-11 pocket meter, use the equations in Table 2. Refer to the values in Table 1 to follow the sample calculations. Note that the ppt NaCl reading is not indicated in Table 1.
According to the National Health Group Pharmacy in Singapore, adults should limit the amount of salt to one teaspoon per day, which is about 5g of salt or 2g of sodium. To ensure that you are not taking more than that amount, always check the amount of sodium per serving on the nutrition information panel of your chili sauce and other packaged or processed food. If that information is not available, simply perform a quick salt test with LAQUAtwin Salt-11 pocket meter.
Do you have any questions or requests? Use this form to contact our specialists.
HORIBA Advanced Techno, Co., Ltd.
31, Miyanonishi-cho, Kisshoin
Minami-ku Kyoto 601-8306 Japan
Tel: +(81) 75 321 7184
Fax: +(81) 75 321 7291
HORIBA Instruments (Singapore) Pte Ltd.
83 Science Park Drive, #02-02A,
The Curie 118258 Singapore
Tel: +65 6 908 9660
Fax: +65 6 745 8155
HORIBA UK Limited Northampton Office
Kyoto Close,Summerhouse Road,
Northampton NN3 6FL UK
Tel: +(44) 1604 542 600
Fax: +(44) 1604 542 699
You might also like to know...