Total Siloxane Analyzer for Biogas Power Generation

Contributing to Siloxane Monitoring and Fuel Quality Control in Biogas Power Generation

Biogas is a mixture of methane, carbon dioxide (CO2), and small quantities of other compounds produced by the anaerobic digestion of organic matter in an oxygen-free environment. The composition of biogas differs depending on the feedstock type: crop and agricultural residues, animal manure, and sludge from wastewater treatment facilities.

Biogas and biogas power generation is renewable energy that contributes to greenhouse gas reduction. Efficient utilization of waste is expected to effectively work as a measure against global warming.

On the other hand, there are still some technical challenges to realize truly environmentally friendly, cost-effective biogas power generation. One of the challenges is the presence of siloxanes in the biogas composition.

Especially biogas, which is produced from sewage sludge as a feedstock, often contains siloxanes due to organic silica in detergents, shampoos, and rinses from domestic wastewater. During combustion in gas engines, siloxanes are sedimented on the internal surface of the gas engine and gas engine parts as white deposits called silica, leading to premature wear and damage to gas engine parts.

Moreover, when high heat is given at the gas turbines or gas engines, siloxanes turn into silica particles and are released into the atmosphere with emissions after combustion, causing serious human health problems such as respiratory, lung, kidney and autoimmune diseases.

Therefore, concentration of siloxanes is monitored and controlled by biogas pretreatment system that removes siloxanes for stable operation and maintenance cost reduction of biogas power generation facilities.

Voices of Sewage Treatment Facility Management and Plant Manufacturers

  • It is important to continuously monitor siloxane before gas engine to ensure its complete removal
  • Want to measure methane and carbon dioxide at the same time with siloxane for quality control of gas engine fuel

 

Solution from HORIBA

Features of Total Siloxane Analyzer

  • Continuous Measurement of Siloxane with High Sensitivity

Provides stable real-time measurement with high sensitivity.

  • In Addition to Siloxane, Methane and Carbon Dioxide Can be Measured (Optional)

Simultaneous measurement of up to 3 components is available. Measurement range for methane is 0-100 vol%, for carbon dioxide - 0-50 vol%.


Total Siloxane Analyzer VA-5000 Series

 

Table:Specification
ComponentSiloxane
Measurement range0-50 ppm
Repeatability +/- 1% of full scale
Linearity +/- 2% of full scale
Zero drift (day) +/- 2% of full scale
Span drift (day) +/- 2% of full scale

HORIBA’s Solution for Biogas Powerplant of Sewage Treatment Facility

There is siloxane removal equipment installed at biogas powerplants of sewage treatment facilities to prevent premature wear and damage of gas engines, which may occur when siloxane adheres to the internal parts of gas engine. The Total Siloxane Analyzer constantly monitors whether the siloxane has been completely removed from biogas at pretreatment equipment and contributes to prevention of failure of the equipment. The Total Siloxane Analyzer also enables simultaneous measurement of methane (CH4) and carbon dioxide (CO2) for fuel quality control prior to gas engine.

*In case of largescale power generation facilities, gas turbines and stream turbines are primary used.


Related Brochures

Related Products

VA-5000 (Siloxane)
VA-5000 (Siloxane)

Total Siloxane Analyzer

제품 문의

HORIBA제품의 자세한 정보를 원하시면, 아래의 양식에 내용을 입력을 부탁드립니다.

* 는 필수입력항목입니다.

Corporate